Asko dryer
showing E1
E1 means the thermistor, the dryer's temperature sensor, has failed.
Mon–Sat, 8am–8pm
- Sensor circuit
- Controls and sensors
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E1
actually means.
E1 means the thermistor, the dryer's temperature sensor, has failed.
ASKO dryer display
What to do when E1 shows on the dryerKind of codeSensor circuit
A thermistor or the moisture sensor bars reading outside their range, or the wiring to them. The reading is checked with a meter before any part is ordered.
Usually leads toControls and sensors
A blank display, a panel that ignores buttons, codes, or cycles that end too soon or never end, traced to the board, timer or sensors.
Shows up asDryer Not Heating
The drum turns and the cycle runs, but the air stays cool and the clothes come out damp.
MakeASKO
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
SourceAsko T208H.W.U instructions for use, Failure display (PDF on the Gorenje Group document server)
Asko Classic T208H and Logic T411HS.
Before you book,
in this order.
Each step comes from ASKO's own guidance for E1 on its dryers. Follow it to the end: the last card says whether this is a visit.
Turn the dryer off for a minute, then restart the drying program.
If E1 shows again, arrange a service visit.
What not to do
E1 on an Asko dryer is about temperature sensing, not the door or the pump.
What you may
notice with it.
The dryer problems E1 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Not Heating
6 causes, cheapest first
Where E1 usually leads
Controls and sensors.
ASKO
dryers.
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
ASKO dryer repair
Electric dryer
The most common dryer in US homes: a 240-volt heating coil, a belt-driven drum and a vent to the outside.
Stackable dryer
The dryer half of a stacked pair or a single-frame laundry center, where the height and the closet decide how the repair is done.
Ventless dryer
Heat-pump and condenser dryers, including 24-inch compacts, that take the water out of the air instead of blowing it outside.
In ASKO's own words
E1 - Thermistor fault.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko Classic T208H and Logic T411HS.
ASKO E1 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E1.
Can I clear E1 myself?
What does the thermistor behind E1 do on an Asko dryer?
Could a clogged filter bring up E1?
Back to your everyday
Still showing E1?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.