Asko dryer
showing E4
E4 asks for the filters to be cleaned; if cleaning does not clear it, the control unit is suspected.
Mon–Sat, 8am–8pm
- Restricted airflow
- Vent cleaning and inspection
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E4
actually means.
E4 asks for the filters to be cleaned; if cleaning does not clear it, the control unit is suspected.
ASKO dryer display
What to do when E4 shows on the dryerKind of codeRestricted airflow
Air is not leaving the dryer fast enough. Lint in the duct, a crushed hose behind the machine or a stuck flap on the outside hood is found long before any part fails.
Usually leads toVent cleaning and inspection
The visit that prevents most dryer fires and many of the repairs above it: the duct, the hood and the lint inside the cabinet.
Shows up asDryer Takes Too Long to Dry
Loads that used to dry in one cycle now need two, or come out damp at the seams.
MakeASKO
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
SourceAsko T208H.W.U instructions for use, Failure display (PDF on the Gorenje Group document server)
Asko heat-pump dryers with a door net filter and a separate heat-pump filter.
Before you book,
in this order.
Each step comes from ASKO's own guidance for E4 on its dryers. Follow it to the end: the last card says whether this is a visit.
Clean the door net filter.
Clean the heat-pump foam filter and its housing.
Book a visit if E4 remains after both filters are clean.
Still there?
It usually turns into vent cleaning and inspection. Book with the code and the model number.
What not to do
E4 is the one Asko code the owner can often clear, because its first remedy is cleaning.
What you may
notice with it.
The dryer problems E4 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Takes Too Long to Dry
5 causes, cheapest first
Where E4 usually leads
Vent cleaning and inspection.
ASKO
dryers.
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
ASKO dryer repairMore ASKO codes
Restricted airflow on other makes
Electric dryer
The most common dryer in US homes: a 240-volt heating coil, a belt-driven drum and a vent to the outside.
Stackable dryer
The dryer half of a stacked pair or a single-frame laundry center, where the height and the closet decide how the repair is done.
Ventless dryer
Heat-pump and condenser dryers, including 24-inch compacts, that take the water out of the air instead of blowing it outside.
In ASKO's own words
E4 - Please clean filters or call service.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko heat-pump dryers with a door net filter and a separate heat-pump filter.
ASKO E4 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E4.
Can I clear E4 myself?
Which filters does E4 refer to on an Asko dryer?
Why does Asko list E4 as a control unit failure?
Back to your everyday
Still showing E4?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.