Asko dryer
showing E2
E2 is a communication error between the dryer's electronic parts.
Mon–Sat, 8am–8pm
- Communication
- Controls and sensors
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E2
actually means.
E2 is a communication error between the dryer's electronic parts.
ASKO dryer display
What to do when E2 shows on the dryerKind of codeCommunication
The main control board and the display board have stopped talking to each other. The harness and its connectors are checked before either board.
Usually leads toControls and sensors
A blank display, a panel that ignores buttons, codes, or cycles that end too soon or never end, traced to the board, timer or sensors.
Shows up asDryer Control Panel Not Responding
Buttons do nothing, the dial turns without effect, or the display is frozen or flickering.
MakeASKO
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
SourceAsko T208H.W.U instructions for use, Failure display (PDF on the Gorenje Group document server)
Asko heat-pump dryers of the TD75 and TD85 platforms (T208H, T411HS).
Before you book,
in this order.
Each step comes from ASKO's own guidance for E2 on its dryers. Follow it to the end: the last card says whether this is a visit.
Power the dryer down, give it one minute, and run the program again.
Book a visit if E2 persists.
What not to do
E2 is distinct from E9, which Asko uses for mismatched software versions between the power board and the user interface.
What you may
notice with it.
The dryer problems E2 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Control Panel Not Responding
5 causes, cheapest first
Where E2 usually leads
Controls and sensors.
ASKO
dryers.
Compact European dryers, mostly condenser and heat-pump models that dry without an outdoor vent.
ASKO dryer repair
Electric dryer
The most common dryer in US homes: a 240-volt heating coil, a belt-driven drum and a vent to the outside.
Stackable dryer
The dryer half of a stacked pair or a single-frame laundry center, where the height and the closet decide how the repair is done.
Ventless dryer
Heat-pump and condenser dryers, including 24-inch compacts, that take the water out of the air instead of blowing it outside.
In ASKO's own words
Communication error.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko heat-pump dryers of the TD75 and TD85 platforms (T208H, T411HS).
ASKO E2 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E2.
Can I clear E2 myself?
Is E2 on an Asko dryer the same as E9?
Why does Asko suggest waiting a minute before restarting after E2?
Back to your everyday
Still showing E2?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.