DryerRepair.center (844) 314-5837Mon–Sat, 8am–8pm Book a visit
An open residential electrical panel in a US home laundry room with a double-pole breaker in the off position among rows of breakers.

Dryer
Tripping Breaker

The breaker for the dryer trips at startup, when the heat comes on, or at random during a cycle.

(844) 314-5837

Mon–Sat, 8am–8pm

  • Fire or gas risk
  • 5 questions that narrow it
  • 5 causes, cheapest first

Book a visit

Three short steps, about a minute.

or call (844) 314-5837

Switch it off before anything else

A breaker that keeps tripping is protecting the house from an electrical problem. Stop using the dryer, leave its breaker off or unplug it, and do not reset it repeatedly. If you smell burning or see scorching at the cord, keep the power off until a technician has looked at it.

What it
usually means.

A breaker trips when more current flows than the circuit is built for, or when current leaks to ground. On an electric dryer, the heating element is by far the largest load, so a trip that happens when the heat comes on points at the element, its wiring or a short to the cabinet. A trip at startup points at the motor or the power cord connection. A 240V dryer breaker is two breakers tied together, and one half can trip while the other holds, which leaves the drum turning with no heat. Repeated tripping is a sign of an electrical problem, not a breaker that needs resetting again.

A coiled dryer heating element in its metal housing lies on a towel beside an open electric dryer in a US home laundry room. The 5 causes, cheapest first

Answer these first

01

Does it trip the moment you press start, or a little later when the heat comes on?
02

Does it trip on an air-only setting, or only on a heated cycle?
03

Is the dryer on its own breaker, or does the circuit feed other outlets too?
04

Is there any scorch mark or melted plastic at the plug or the cord connection on the back?
05

Has the dryer been moved recently, or the power cord changed?

Check these
before you book.

Dryer tripping breaker: 5 checks, and none of them costs anything.

01

Leave the breaker off and unplug the dryer; do not keep resetting it to see if it holds.

02

Note exactly when it tripped: at start, when the heat came on, or at a random point.

03

With the power off, look at the plug and the outlet for scorch marks or melted plastic.

Also worth checking

  • Check the panel label to confirm the dryer has its own double breaker.
  • Tell us whether the dryer is electric or gas; a gas dryer draws far less and trips for different reasons.

The causes,
cheapest first.

5 things dryer tripping breaker turns out to be, from heating element shorted to ground to worn or undersized breaker.

The cost guide
  1. 01 low to moderate

    Heating element shorted to ground

    A broken coil touching the heater housing sends current to the cabinet. It trips on heat and not on air-only, which is a useful clue.

    Fixed by heating element repair On an electric dryer
  2. 02 low

    Burned terminal block or loose cord

    The connection where the power cord meets the dryer can loosen and overheat. Scorching there is a hazard in its own right and needs repair before the dryer runs again.

    Book a diagnostic visit
  3. 03 low to moderate

    Moisture or a damaged wire inside

    A wire chafed against the cabinet, or water reaching a connection, leaks current to ground. It can trip only on some loads, which makes it look random.

    Book a diagnostic visit
  4. 04 moderate

    Motor drawing too much current

    A motor straining against a seized pulley, a failed roller or worn bearings pulls more current at startup than it should.

    Fixed by motor and blower repair
  5. 05 varies

    Worn or undersized breaker

    Breakers do wear, and a dryer sharing a circuit it was not meant to share will trip for reasons that are not in the dryer. That fix belongs to an electrician.

    Book a diagnostic visit
  6. What it costs

    Every repair on the site's cost scale, side by side

    Open the cost guide

The makes
it happens on.

14 makes on this site; dryer tripping breaker can show up on any of them. Each mark opens that make's own page.

All 14 brands

Dryer Tripping Breaker,
where we come out.

9 metros, each with its own page.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A parent and a child folding warm towels together on top of a front-load dryer in a bright laundry room
For the heart of your home.

Questions about
dryer tripping breaker.

The drum turns but there is no heat. Could that be the breaker?
Yes. A 240V dryer breaker has two halves, and when one trips, the motor can keep running on the other while the heating element gets nothing. Switch the dryer's breaker fully off, then back on, before assuming the heater has failed.
Does a gas dryer trip breakers?
Less often. A gas dryer runs on a standard 120V outlet and uses power only for the motor, the drum light, the igniter and the controls. A trip there usually points at the motor or a shared circuit.
Is it the dryer or the house wiring?
If the dryer trips on its own dedicated breaker and only when the heat comes on, the dryer is the likely cause. If other outlets share the circuit or it trips with the dryer unplugged, an electrician should look at the circuit.
Can I just install a bigger breaker?
No. The breaker is sized to protect the wire in the wall, not the dryer. A larger breaker lets that wire overheat, which is a fire risk.

Back to your everyday

Still seeing dryer tripping breaker?

Book with what you checked above — 5 answers save the technician the first part of the visit.

Schedule a repair Call (844) 314-5837
(844) 314-5837 Schedule a repair