Miele dryer
showing F66
F66 means the air path is clogged: either the lint filters or the plinth filter in front of the heat exchanger is soiled.
Mon–Sat, 8am–8pm
- Restricted airflow
- Vent cleaning and inspection
- Source: Miele
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F66
actually means.
F66 means the air path is clogged: either the lint filters or the plinth filter in front of the heat exchanger is soiled.
Miele dryer display
What to do when F66 shows on the dryerKind of codeRestricted airflow
Air is not leaving the dryer fast enough. Lint in the duct, a crushed hose behind the machine or a stuck flap on the outside hood is found long before any part fails.
Usually leads toVent cleaning and inspection
The visit that prevents most dryer fires and many of the repairs above it: the duct, the hood and the lint inside the cabinet.
Shows up asDryer Takes Too Long to Dry
Loads that used to dry in one cycle now need two, or come out damp at the seams.
MakeMiele
Compact European dryers, mostly heat-pump models that dry at lower temperatures without an outdoor vent.
SourceMiele USA customer assistance, tumble dryer code F66 (Wayback copy)
Miele heat-pump dryers with a plinth (toe-kick) filter.
Before you book,
in this order.
Each step comes from Miele's own guidance for F66 on its dryers. Follow it to the end: the last card says whether this is a visit.
Remove both lint filters, clean them, rinse them under warm water and dry them thoroughly.
Open the heat exchanger access panel, pull out the plinth filter and clean it over a bowl or bucket.
Reinstall everything and book a visit if F66 returns.
Still there?
It usually turns into vent cleaning and inspection. Book with the code and the model number.
What not to do
F66 has nothing to do with an outdoor vent; this dryer recirculates its air through filters.
What you may
notice with it.
The dryer problems F66 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Takes Too Long to Dry
5 causes, cheapest first
Where F66 usually leads
Vent cleaning and inspection.
Miele
dryers.
Compact European dryers, mostly heat-pump models that dry at lower temperatures without an outdoor vent.
Miele dryer repairMore Miele codes
Restricted airflow on other makes
In Miele's own words
The lint filters are soiled.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele heat-pump dryers with a plinth (toe-kick) filter.
Miele F66 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F66.
Can I clear F66 myself?
After cleaning for F66, why must the Miele lint filters be dry before going back in?
Should the lint I clean out for F66 go down the drain?
Back to your everyday
Still showing F66?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.