Maytag dryer
showing F4 E1
The Maytag control has found a problem with the heater or with the relays that switch it.
Mon–Sat, 8am–8pm
- Heating
- Heating element repair
- Source: Maytag
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F4 E1
actually means.
The Maytag control has found a problem with the heater or with the relays that switch it. It could be the element or burner side, or the board parts that feed them.
Maytag dryer display · also shown as F4E1
What to do when F4 E1 shows on the dryerKind of codeHeating
The dryer expected heat and did not get it, or got it too slowly. On an electric model the element and its wiring; on a gas model the igniter, the flame sensor and the valve coils. A blocked vent is ruled out first.
Usually leads toHeating element repair
No heat or weak heat on an electric dryer, traced to the coil, its terminals or the safety parts on its housing.
Shows up asDryer Not Heating
The drum turns and the cycle runs, but the air stays cool and the clothes come out damp.
MakeMaytag
Full-size dryers in electric and gas versions, from a Whirlpool-owned brand that shares many of its parts.
SourceMaytag product help: F4 E1 heater system
Maytag electronic-control dryers with the F/E code display, electric and gas.
Before you book,
in this order.
Each step comes from Maytag's own guidance for F4 E1 on its dryers. Follow it to the end: the last card says whether this is a visit.
Switch the breaker off for a minute and back on.
Try a Timed Dry cycle and watch the panel for a minute.
Book a visit if F4 E1 shows again.
What not to do
F4 E1 is not the low-voltage message; Maytag reports a house supply problem separately, as L2 or F4 E4.
What you may
notice with it.
The dryer problems F4 E1 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Not Heating
6 causes, cheapest first
Where F4 E1 usually leads
Heating element repair.
Maytag
dryers.
Full-size dryers in electric and gas versions, from a Whirlpool-owned brand that shares many of its parts.
Maytag dryer repair
Electric dryer
The most common dryer in US homes: a 240-volt heating coil, a belt-driven drum and a vent to the outside.
Gas dryer
Heat from a burner on natural gas or propane, lit by an igniter and watched over by a flame sensor, with the motor on 120 volts.
Stackable dryer
The dryer half of a stacked pair or a single-frame laundry center, where the height and the closet decide how the repair is done.
In Maytag's own words
F4 E1: Heater System
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Maytag electronic-control dryers with the F/E code display, electric and gas.
Maytag F4 E1 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F4 E1.
Can I clear F4 E1 myself?
Does F4 E1 on a Maytag always mean a burned-out element?
Can I still use air-only cycles on my Maytag with F4 E1?
Back to your everyday
Still showing F4 E1?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.