Maytag dryer
showing F4 E3
Maytag uses F4 E3 when the exhaust air is held back.
Mon–Sat, 8am–8pm
- Restricted airflow
- Vent cleaning and inspection
- Source: Maytag
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F4 E3
actually means.
Maytag uses F4 E3 when the exhaust air is held back. A packed lint screen, a duct flattened behind the cabinet, a kinked run or a vent with too many turns will all raise it.
Maytag dryer display · also shown as F4E3
What to do when F4 E3 shows on the dryerKind of codeRestricted airflow
Air is not leaving the dryer fast enough. Lint in the duct, a crushed hose behind the machine or a stuck flap on the outside hood is found long before any part fails.
Usually leads toVent cleaning and inspection
The visit that prevents most dryer fires and many of the repairs above it: the duct, the hood and the lint inside the cabinet.
Shows up asDryer Vent Clogged
Weak airflow outside, long drying times and a hot laundry room: the vent is not carrying the air away.
MakeMaytag
Full-size dryers in electric and gas versions, from a Whirlpool-owned brand that shares many of its parts.
SourceMaytag product help: F4 E3 error code (dryer)
Maytag electronic dryers with the two-part F/E display.
Before you book,
in this order.
Each step comes from Maytag's own guidance for F4 E3 on its dryers. Follow it to the end: the last card says whether this is a visit.
Clean the lint screen; on a Pet Pro model check it after every pet load.
Move the dryer out a few inches and straighten or replace any crushed transition duct.
Make sure the outdoor vent hood is free of lint, then run a Timed Dry heated cycle.
If the code keeps coming back, get the whole vent run cleaned or book a visit.
Still there?
It usually turns into vent cleaning and inspection. Book with the code and the model number.
What not to do
The heating parts are not the first suspect. A dryer with F4 E3 can heat perfectly and still dry slowly because the hot air cannot get out.
What you may
notice with it.
The dryer problems F4 E3 tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Vent Clogged
5 causes, cheapest first
Where F4 E3 usually leads
Vent cleaning and inspection.
Maytag
dryers.
Full-size dryers in electric and gas versions, from a Whirlpool-owned brand that shares many of its parts.
Maytag dryer repairMore Maytag codes
Restricted airflow on other makes
Electric dryer
The most common dryer in US homes: a 240-volt heating coil, a belt-driven drum and a vent to the outside.
Gas dryer
Heat from a burner on natural gas or propane, lit by an igniter and watched over by a flame sensor, with the motor on 120 volts.
Stackable dryer
The dryer half of a stacked pair or a single-frame laundry center, where the height and the closet decide how the repair is done.
In Maytag's own words
the vent may be crushed, kinked, or have too many turns.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Maytag electronic dryers with the two-part F/E display.
Maytag F4 E3 dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F4 E3.
Can I clear F4 E3 myself?
Does Pet Pro make F4 E3 more likely on a Maytag?
How do I clear F4 E3 from my Maytag display?
Back to your everyday
Still showing F4 E3?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.