LG Signature dryer
showing HS
HS on the Signature dryer is a humidity sensor failure; that sensor is how the dryer decides a load is dry.
Mon–Sat, 8am–8pm
- Sensor circuit
- Controls and sensors
- Source: LG SIGNATURE
Book a visit
Three short steps, about a minute.
or call (844) 314-5837
Loading appointment form…
The appointment form couldn’t load. Please try again.
What HS
actually means.
HS on the Signature dryer is a humidity sensor failure; that sensor is how the dryer decides a load is dry.
LG SIGNATURE dryer display
What to do when HS shows on the dryerKind of codeSensor circuit
A thermistor or the moisture sensor bars reading outside their range, or the wiring to them. The reading is checked with a meter before any part is ordered.
Usually leads toControls and sensors
A blank display, a panel that ignores buttons, codes, or cycles that end too soon or never end, traced to the board, timer or sensors.
Shows up asDryer Takes Too Long to Dry
Loads that used to dry in one cycle now need two, or come out damp at the seams.
MakeLG SIGNATURE
LG's premium line, with laundry models built to a higher finish and more electronics than LG's main range.
SourceLG DLEX9500*/DLGX9501* dryer owner's manual MFL67731093 (PDF on LG's document server)
Signature electric and gas dryers covered by owner's manual MFL67731093.
Before you book,
in this order.
Each step comes from LG SIGNATURE's own guidance for HS on its dryers. Follow it to the end: the last card says whether this is a visit.
Switch the dryer off.
Book a visit; the Signature manual gives no owner remedy for HS.
What not to do
HS is not a vent or heat problem. Heat and airflow can be fine while the dryer cannot judge dryness.
What you may
notice with it.
The dryer problems HS tends to arrive with. Answer these at the dryer before anyone is booked.
All problems
Dryer Takes Too Long to Dry
5 causes, cheapest first
Where HS usually leads
Controls and sensors.
LG SIGNATURE
dryers.
LG's premium line, with laundry models built to a higher finish and more electronics than LG's main range.
LG SIGNATURE dryer repair
In LG SIGNATURE's own words
Humidity Sensor failure.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Signature electric and gas dryers covered by owner's manual MFL67731093.
LG SIGNATURE HS dryer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about HS.
Can I clear HS myself?
Why does the Signature manual not tell me to clean the sensor for HS?
Can HS show up during the Signature installation test?
Back to your everyday
Still showing HS?
Book with the code exactly as displayed, the whole model number, and whether you smell burning or gas — for a code, that is where the diagnosis starts.