A white front-loading electric dryer stands on a tiled floor in a US home laundry room.

Samsung
Dryer Repair

Full-size and stacked dryers in electric and gas versions, built around electronic controls and sensor drying.

(844) 314-5837

Mon–Sat, 8am–8pm

  • 4 dryer types
  • 6 problems we see
  • 8 error codes

Book a visit

Three short steps, about a minute.

or call (844) 314-5837

Samsung dryers,
specifically.

Samsung builds sensor-driven dryers in electric and gas versions and publishes its display codes in groups: voltage, temperature, heating, the door, communication between boards. Many models can also test their own exhaust, so a visit rules airflow in or out before it moves to the heat source and the electronics.

The Samsung lineup

What is particular
to Samsung.

Samsung sells electric and gas dryers with a digital display and simpler models that show problems as blinking lights instead. The heat source and the display type both change what a visit looks for.

A vent test built into the controls

Many Samsung dryers run a short vent blockage test from a button combination and report the result as a code. A clean result sends the diagnosis inside the dryer; a clog result sends it to the duct.

Heat that backs off on purpose

When a Samsung dryer senses that heat and moisture are not escaping, it can reduce or stop its heat to protect the vent. A lukewarm dryer on a blocked duct is behaving as designed, and replacing the heater would not fix it.

Two circuits on electric models

An electric Samsung draws on two circuits, and if only one trips the drum still turns while the heater stays cold. Cycling the breaker off and on is the first check on a spins-but-no-heat call.

Sensor bars at the front of the drum

Sensor Dry cycles end when two curved metal bars at the front of the drum feel dry laundry. Dryer-sheet film on those bars can end a cycle early with wet clothes, and a wipe with a drop of dish soap fixes it.

Parts

Heating elements, thermal parts, sensors and door switches for Samsung dryers are widely stocked, while boards are matched to the exact model and may need ordering. The model code from the label inside the door is confirmed first.

Repair or replace

Most Samsung dryer calls come down to airflow, a heat-circuit part or a sensor, all of which are repaired rather than replaced. Replacement enters the discussion when a board failure coincides with worn drum parts on an older unit.

Book your Samsung visit

Not a
Samsung?

Samsung is one of 14 dryer makes on this site. The other 13 each have a page of their own.

All 14 brands
A parent and a child folding warm towels together on top of a front-load dryer in a bright laundry room
For the heart of your home.

Questions about
Samsung dryers.

How do I run the vent test on my Samsung dryer?
With the drum cool and empty, press Adjust Time Up and Dry Level together until In or Ins shows, then press and hold Start/Pause and keep the door shut. Some models use Cycle 1 plus Wrinkle Prevent, or Air Fluff plus Wrinkle Prevent, to enter the test. A 0 or End result means the duct passed; CLg, Cg, C80 or C90 means it found a clog.
Why does my Samsung dryer spin but not heat?
On an electric model, one of the two household circuits may have tripped while the other still runs the drum. Turn the breaker off for 30 seconds and back on. If the heat is still missing, run the vent test, because the dryer also cuts heat when it senses a blocked exhaust.
My Samsung dryer stops after a few minutes and the clothes are soaking wet. What is wrong?
Samsung points to dirty moisture sensors for exactly that pattern. Wipe the two metal bars at the front of the drum with a soft cloth and a drop of dish soap, and dry at least about four towels' worth so the load actually touches them.

Back to your everyday

Book your Samsung visit.

Have the dryer's model number ready — on Samsung it decides which parts come on the first visit.

(844) 314-5837 Schedule a repair